DC12-72V Max.1500m/4900ft Long Range RF Garage Wireless Remote Control Switch

Description

Max. 1500m/4900ft Long Range RF Wireless Remote Control Switch for Garage Door, DC12-72V 50/60Hz, 30A Relay with 2 Remote Controls
Working Voltage: Voltage: DC12-72V, Output Current: 30A, RF Working frequency: 433MHz
Outdoor receiving distance：1500m/4900ft(without barrier)
Indoor receiving distance：200m/650ft(two wall permitted)
2 wireless remote controllers, can control 1 receiver at the same time
Aplication: remote control garage door, electrical equipment on/off status
Application:
Wireless control switches in farms, homes, offices and other places, remote control (garage door, electrical equipment, etc.) on/off status.
Specification:
Receiver:
Working Voltage: DC12-72V
Output Current: 30A
Wireless signal frequency: 433MHz
Power consumption: ＜0.5W
Cable length of antenna: 3m(10ft)
Receiver size: 10 x 5.3 x 2.8cm
Remote controller:(included 9V battery)
Remote controller size: 15 x 4.2 x 2.5cm
Outdoor receiving distance:1500m/4900ft(without barrier)
Indoor receiving distance:200m/650ft(two wall permitted)
Material: ABS + PC
Total weight: 13.6oz(385g)
Package Content:
2 x Remote Controller(included 9V battery)
1 x Receiver(with antenna)
1 x Manual
Notes:
1.When wiring, be careful to current leakage.
2.When wiring, ensure correct connection of the positive and negative poles.
3.Before pairing, ensure the switch receiver is wired in circuit.
4.The antenna has to connect with the switch receiver.
5.When pressing the button of the receiver, you need to use some extent force, or it cannot work.
6.Please do not wire with wrong voltage (AC cannot wire into DC)
Code learning steps:
1. Turn on the power key of remote controller.
2. Press for several seconds until the indicator light turns green.
3. Code pairing and cleaning:
Model 1: press the button until the indicator light flashes once , then press the ON or OFF key of the remote controller. The light is controlled by one key of ON or OFF, another key is spare.
Code cleaning: if you want shift the working model, you have to reset it firstly by cleaning the code. Press the button until the indicator light flashes trice.
Model 2: press the button until the indicator light flash twice , then press the ON key ; and then press the OFF key. The light is controlled by both ON and OFF key.